Vulcan-hart VC4ED Manuel d'utilisateur télécharger pdf (Page 9)

FULL SIZE ELECTRIC CONVECTION OVEN - REMOVAL AND REPLACEMENT OF PARTS

F25105 (December 2001)Page 9 of 60

5. Remove probe by pushing it through the oven

wall and into the control panel area.

NOTE:

The hole in the oven cavity wall does not

line up straight with the oven cavity outer shell,

therefore the probe must be removed at an angle.

6. Reverse the procedure to install the

replacement probe.

7. Adjust the temperature control as outlined

under "SOLID STATE TEMPERATURE

CONTROL CALIBRATION" in "SERVICE

PROCEDURES AND ADJUSTMENTS".

HEATING ELEMENTS

WARNING:

DISCONNECT THE ELECTRICAL

POWER TO THE MACHINE AT THE MAIN

CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT

BOX INDICATING THE CIRCUIT IS BEING

SERVICED.

NOTE:

Starting with production in October, 2001,

the top cavity panel will have 3/4" square holes for

easier element removal. Ovens manufactured prior

to this date have 1/2" round holes that sometimes

make it difficult to remove elements thru the cavity.

A serial number cut off will not

be available. Follow

the procedures for element removal as outlined

below.

Front Access

1. Remove the oven racks and rack supports.

2. Remove the "top" door seal from the oven.

3. Determine if the heating element to replace is

on the left

or right side in the oven cavity. The

element locations from front to back are: Right

side - R1, R2 & R3; Left side - R4, R5 & R6.

A. Measure the current draw of the heating

elements as outlined under "HEATING

ELEMENT TEST" in "SERVICE

PROCEDURES AND ADJUSTMENTS".

4. From inside the oven cavity, remove the

perforated panel from the same side of the

element being replaced.

A. If removing the right side panel, also

remove the probe guard or mounting clips.

B. Run the probe wire thru the panel opening

before lifting panel out.

5. From the element being replaced, remove the

hold down clamps, the mounting bracket

screws at the top, then remove the element.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Vulcan-hart VC4ED Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Fours à convection Vulcan-hart VC4ED