Vulcan-hart VSX7EC ML-114822 Manuel d'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
– 4 –
INSTALLATION CODES AND STANDARDS
In the United States, the steamer must be installed in accordance with the following: (1) State and local
codes and (2) National Electrical Code, ANSI/NFPA-70 (latest edition), available from National Fire
Protection Association, Batterymarch Park, Quincy, MA 02269.
In Canada, the steamer must be installed in accordance with the following: (1) Local codes and (2)
Canadian Electrical Code, Part 2, CSA Standard C22.1 (latest edition), available from Canadian
Standard Association, 178 Rexdale Boulevard, Rexdale, Ontario, Canada M9W1R3.
LEVELING
Using a spirit level or pan of water in the bottom of the steamer, adjust the leveling feet to level the
steamer front to back and side to side.
Mark hole locations on the floor through the anchoring holes provided in the flanged adjustable feet.
Remove the steamer and drill holes at marked locations on the floor. Insert proper anchoring devices.
Set steamer back in proper position.
Install bolts through anchoring holes and into anchors to secure the steamer to the floor. Seal bolts and
flanged feet with Silastic.
After the drain is connected, check for level by pouring water onto the floor of the compartment.
All water should drain through the opening at the back of the compartment cavity.
ELECTRICAL CONNECTION
WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH
APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL
ELECTRICAL CODES.
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW
LOCKOUT / TAGOUT PROCEDURES.
Make electrical connection through the 1
1
/8" (2.9 cm) diameter hole, provided, using
3
/4" (1.9 cm) trade-
size conduit. Refer to the wiring diagram located inside the right side panel. Use 90°C minimum
insulated wire.
ELECTRICAL DATA
Model kW Volts/Hertz/Phase
Minimum Circuit Ampacity
Maximum Protective Device
Amps
VSX7EC
VSX7EO
17.5
208/60/3
240/60/3
480/60/3
60
50
30
VSX10EC
VSX10EO
30
208/60/3
240/60/3
480/60/3
90
80
45
Vue de la page 3
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire