Vulcan-Hart GPC12S Manuel de service télécharger pdf (Page 3)

TABLE OF CONTENTS

Important Safety Information Page 2

Codes and Standards Information Page 3

Manual Use Information Page 3

Data Plate Information Page 3

Service Warnings Page 3

Tools Required for Servicing Page 3

Section l Service Checks Pages 4-8

Section ll Service Adjustments Pages 9-10

Section lll Removal and Replacement of Controls Pages 11-57

Section lV Wiring Information Page 58

CODES AND STANDARDS

Vulcan-Hart Pasta Cookers are to be installed in accordance with state and local codes, or in the absence of local

codes, the National Fuel Gas Code, ANSI-Z223.1 (latest edition), available from the American Gas Association,

Inc., 1515 Wilson Boulevard, Arlington, VA. 22209 and with ANSI-NFPA Standard #96 (latest edition),

Vapor

Removal From Cooking Equipment,

available from the National Fire Protection Association, Batterymarch

Park, Quincy, MA 02269.

HOW TO USE THIS MANUAL

This Manual is dedicated to the servicing of the GPC Series Vulcan Gas Pasta Cooker.

The Manual is divided into 4 sections, SERVICE CHECKS, SERVICE ADJUSTMENTS, REMOVAL OF

CONTROL PANEL AND REPLACEMENT OF CONTROLS and WIRING INFORMATION. Refer to the Manual

Table of Contents when looking for specific performance checks or procedures. For additional Technical

assistance contact the Vulcan Hart Service Dept. at the phone number shown on the cover of this manual. Read

the following rating plate information and service warnings before preforming any service work.

RATING PLATE

The rating plate stating model number, serial number, manufacturing date, gas type, voltage and amperage is

located on the inside cooker cabinet door panel.

SERVICE WARNINGS

Hot water and parts can cause burns, use care when servicing this appliance.

If cooker is pulled from the installation area for servicing, reinstall the cooker at least 6" away from any

combustible construction sides and back and 0" away from noncombustible construction.

The high limit is a shut off device which senses the temperature of the appliance to prevent over heating. The

high limit operates independently and will automatically cause equipment shut down should the primary control

fail. If this situation occurs, DO NOT attempt to bypass the high limit. Low water level will cause the high limit

to trip.

TOOLS REQUIRED

The following is a listing of tools required to perform the service checks in this manual

1. Standard set of hand tools.

2. Volt Meter with a sensitivity of at least 20,000 ohms per volts.

3. Temperature tester (thermocouple or digital pyrometer).

4. Gas test kit.

1 2 3 4 5 6 7 8 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Vulcan-Hart GPC12S Manuel de service Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Fabricants de pâtes et de ravioli Vulcan-Hart GPC12S