Vulcan-hart VCD44 ML-138069 Manuel d'utilisateur télécharger pdf (Page 4)

VCD SERIES CHIP WARMER F-38053 (02-13)

3

GENERAL

INTRODUCTION

Vulcan-Hart Chip Warmers are

produced with quality workmanship and

material. Proper installation, usage, and

maintenance of your warmer will result

in many years of satisfactory

performance.

It is suggested that you thoroughly read

this entire manual and carefully follow all

of the instructions provided.

As with any piece of food service

equipment, this Chip Warmer requires a

minimum of care and maintenance.

Recommended procedures are

contained in this manual and should

become a regular part of the operation

of the unit.

INSTALLATION

Before installing, verify that the electrical

service agrees with the specifications on

the rating plate located on the lower

back corner of the warmer. If the supply

and equipment requirements do not

agree, do not proceed with unpacking

and installation. Contact your Vulcan-

Hart Customer Service Department

immediately. (Fig. 4)

UNPACKING:

The Warmer was inspected before

leaving the factory. The transportation

company assumes full responsibility for

safe delivery upon acceptance of the

shipment. Immediately after unpacking,

check for possible shipping damage to

the warmer.

If the warmer is found to be

damaged, save the packaging

material and contact the carrier

within 15 days of delivery.

Carefully unpack warmer and place in a

work accessible area.

1. Remove banding holding the

carton to the pallet.

2. Carefully remove warmer from

carton and place on floor or table.

3. Remove any and all packaging

materials inside unit.

4. Peel off all vinyl protection film.

5. Thoroughly clean the warmer as

described in the cleaning instruct-

ions in this manual.

1 2 3 4 5 6 7 8 9 ... 12 13

Commentaires sur ces manuels

Pas de commentaire