Vulcan-hart ML-103837 Manuel d'utilisateur télécharger pdf (Page 5)

– 5 –

INSTALLATION

UNPACKING

This cheesemelter was inspected before leaving the factory. The transportation company assumes full

responsibility for safe delivery upon acceptance of the shipment. Immediately after unpacking, check

for possible shipping damage. If the cheesemelter is found to be damaged, save the packaging

material and contact the carrier within 7 days of delivery.

1. Unpack cheesemelter and remove all packaging materials.

• Heater and legs on countertop and pass through models, and heaters on wall mounted

models, will be found wrapped and fastened to the floor inside the cheesemelter.

2. Screw in the four legs provided.

3. Place cheesemelter on a flat horizontal surface at the desired location.

4. Level the cheesemelter (if needed) by turning the adjustable bottom part of the legs. See sketch

below.

LOCATION

Do not install pass through cheesemelters on a wall. Pass through cheesemelters must be installed

with adequate clearances for servicing and proper operation.

Do not operate countertop and pass through cheesemelters without the legs in place. Damage to the

countertop may result.

1 2 3 4 5 6 7 8 9 10 ... 23 24

Pas de commentaire

Vulcan-hart ML-103837 Manuel d'utilisateur Page 5