Vulcan-hart VHA9 ML-138072 Manuel d'utilisateur télécharger pdf (Page 11)

V SERIES FOOD HOLDING, TRANSPORT, AND BANQUET CARTS F-41141 (11-09)

THERMOSTAT

1. Remove the Cover.

2. Identify and remove the two (2)

screws that hold the thermostat

sensing bulb on the inside of the

cabinet. It will be mounted to the

top of the cabinet. Push/pull the

thermostat bulb through the

access hole located in the top of

the cabinet

3. Turn the black Thermostat Knob

to the “OFF” position.

4. Remove the black thermostat

knob from the control panel by

using an allen wrench to loosen

the two (2) set screws that hold it

to the thermostat stem. (Fig. 15)

THERMOSTAT KNOB SET SCREWS

Fig.15

5. Refer to the wiring diagram to

identify the electrical leads that

connect to the thermostat.

6. Disconnect the wire leads

connected to the thermostat.

7. Remove the two (2) screws on

the front of the control panel that

hold the thermostat in place and

remove the thermostat.

8. Install the replacement

thermostat temperature sensing

probe by reversing the steps

above.

9. Reconnect the cabinet to its

power source and test.

THERMOSTAT CALIBRATION

1. Turn thermostat knob to Off

position.

2. Loosen set screws and remove

knob.

3. Using a small screw driver, turn

the screw in the center of the

thermostat stem: “clockwise

to Decrease” temperature or

“counter-clockwise

to Increase”

temperature. (Fig. 16)

Fig. 16

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Vulcan-hart VHA9 ML-138072 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Chauffe-eau Vulcan-hart VHA9 ML-138072